Headquarter: Chemical Industry Park, Economic Development Zone,  JiNan City,  ShanDong Province, China.

Phone +86-152 8958 7728

Angela@BlueSkytcca.com

Caustic Piping Remedies – Products Finishing

When I reviewed our operations, I was struck by how many of our PVC and CPVC piping joints that carried either caustic for wastewater pretreatment or alkaline cleaner exhibited a crusty scale, apparently dried caustic residue.
#pollutioncontrol

Q. Recently, I have been promoted and now have responsibility for both our plating operations and its wastewater pretreatment system. When I reviewed our operations, I was struck by how many of our PVC and CPVC piping joints that carried either caustic for wastewater pretreatment or alkaline cleaner exhibited a crusty scale, apparently dried caustic residue. Also, many joints also exhibited weeping of the caustic or alkaline cleaner. I was told that this has “always been like this.”
I find this unacceptable, mainly due to safety concerns. Do you have any suggestions on how to remedy these caustic leaks? D.E.
 
A. It seems like every several years I get a question similar to the one you posed. I have been involved in the metal finishing industry for over 30 years, and for most of the time, I, too, wondered why PVC caustic piping always leaked.
As I have written in previous articles, the PVC/CPVC glues commonly used by mechanical/plumbing contractors as well as your own maintenance personnel contain fumed silica, very small glass-like particles used to thicken the glue. Caustic solutions dissolve the silica, resulting in leaks and failures. Evidence of this is the crystallized white caustic that “balls” around the leaky joints as you have observed. In addition to properly preparing the pipe for joining, there are PVC/CPVC glues available that do not contain fumed silica and are specifically designed for caustic and/or sodium hypochlorite (bleach that contains some free caustic as stabilizer) service; these are available, but you must specifically request them.
Also, we strongly recommend that you use glued joints for piping and valves, but if you must use a threaded joint, make sure the joints are clean and sharp and use sealing tape that meets the military specification T-27730A.
The following are other recommended actions to minimize leaky joints and improve piping reliability:
Using the right methods and material will give you the best shot at achieving your goals.
 
Our experts share specific questions about zinc phosphate and pretreatment
Wastewater from plating facilities contains contaminants such as heavy metals, oil and grease and suspended solids at levels that might be considered environmentally hazardous . . .
I am looking for safety/environmental requirements to set up a nitric acid cleaning and passivation system.
Copyright © Gardner Business Media logo  2023 Privacy Policy
[Log On]

source

Leave a Reply

Your email address will not be published.

*